1. Dusting - We begin by dusting off millwork
areas where caulking is to be applied.
2. Caulking - We caulk all gaps and cracks
in and around baseboard, door jambs, window trim, crown molding, wainscoat, and
all other architectural trim work to be painted.
3.
Filling - We fill all holes and other needed areas with a premium quality
spackling paste. We leave extra on each area to allow for shrinkage and to insure
a smooth finish after sanding.
4. Sanding - We completely sand all millwork surfaces to be painted to a very smooth finish.
5.
Hardware - We remove all hardware including hinges, knobs, and catches. We
also label and remove all doors.
6. Masking - We carefully mask and cover all unprotected areas including: previously painted
walls and ceilings, floors, lighting fixtures etc.
7.
Set-up - We make a spray booth in the largest room of the home or in the garage
and set-up all doors to be painted.
8. Dust
removal - We carefully and completely vacume all floor areas near millwork.
We then tack cloth all millwork surfaces to be painted.
9.
Primer - We apply (spray finish) one full coat premium quality enamel undercoat
on all millwork surfaces (including pre-primed).
10.
Sanding & inspection - We completely sand all millwork again with sanding
sponges. While sanding, we inspect all millwork areas to assure a quality finish.
11.
Dust removal - We vacume and tack cloth all areas again to assure a dust free
environment.
12. Finish coat - We apply 1 or 2 finish coats of premium quality oil based or acrylic based enamel on all millwork surfaces. Finish coat(s) is/are applied by airless sprayer using a fine finish tip or by HVLP sprayer. All paint is applied evenly and professionally. The finish coat will dry to a beautiful smooth glass like finish.
13.
Clean-up - After allowing the finish coat to cure
well. We remove all masking, replace all hardware, and
re-hang all doors.
14. Inspection - We inspect all painted areas for quality assurance.
